| Title | Measured Ground-Surface Movements, Cerro Prieto Geothermal Field |
|---|---|
| Authors | B. L. Massey |
| Year | 1981 |
| Conference | DOE-CFE Symposium on Cerro Prieto |
| Keywords | |
| Abstract | The Cerro Prieto geothermal area in the Mexicali Valley, 30 kilometers southeast of Mexicali, Baja California, incurred slight deformation because of the extraction of hot water and steam, and probably, active tectonism. During 1977-78, the U.S. Geological Survey established and measured two networks of horizontal control in an effort to define both types of movement. These networks consisted of: (1) A regional trilateration net brought into the mountain ranges west of the geothermal area from stations on an existing U.S. Geological Survey crustal-strain network north of the international border; and (2) a local net tied to stations in the regional net and encompassing the present and planned geothermal production area. Electronic distance measuring instruments were used to measure the distances between stations in both networks in 1978, 1979 and 1981. Lines in the regional net averaged 25 km. in length and the standard deviation of an individual measurement is estimated to be approximately 0.3 part per million of line length. The local network was measured using different instrumentation and techniques. The avera~e line length was about 5 km. and the standard deviation of an individual measurement approached 3 parts per ~illion per line length. Ground-surface movements in the regional net, as measured by both the 1979 and 1981 resurveys, were small and did not exceed the noise level. The 1979 resurvey of the local net showed an apparent movement of 2 to 3 centimeters inward toward the center of the production area. This apparent movement was restricted to the general limits of the production area. The 1981 resurvey of the local net did not show increased movement attributable to fluid extraction. El area geotermica de Cerro Prieto en el Valle de Mexicali, 30 kilometros al sudeste de Mexicali, Baja California, sufrio una leve deformacion debido a la extraccion de vapor y agua caliente y, probablemente, a un tectonismo activo. Durante 1977-1978, el U.S. Geological Survey establecio y relevo dos redes de control horizontal con el fin de definir ambos tipos de movimiento. Estas redes consisten en: (1) una red regional de trilateracion extendida hasta las sierras situadas al oeste del area geotermica desde estaciones de una red del U.S. Geological Survey establecida anteriormente para medir la deformacion de la corteza al norte de la frontera internacionalj y (2) una red local ligada a las estaciones de la red regional y que cubre las zonas de produccion geotermica actual y futura. En 1978, 1979 Y 1981 se utilizaron instrumentos electronicos de medicion de distancias para determinar las distancias entre las estaciones de ambas redes. La longitud promedia de las lineas de la red regional fue de 25 km, y la desviacion estandar de cada medicion se estimo en aproximadamente 0.3 partes por millon de longitud de linea. La red local fue medida utilizando diferentes instrumentos y tecnicas. La longitud promedio de las lineas fue aproximadamente 5 km y la desviacion estandar de cada medicion fue de unas 3 partes por millon de longitud de linea. En la red regional los movimientos de la superficie del terreno determinados por los levantamientos que se repitieron en 1979 y 1981 fueron pequenos y no excedieron el nivel de ruido. La repeticion del levantamiento de la red local realizada en 1979 mostro un movimiento aparente de 2 a 3 cm hacia el centro del area de produccion. Este movimiento aparente estuvo restringido a los limites generales del area de produccion. La repeticion del levantamiento de la red local completada en 1981 no mostre un aumento del movimiento atribuible a la extraccion de fluidos. |